🛑 Cayenne Diesel [waiting for beta tester responses]

[jeff]

It also looks like your car is responding to the TPMS parameters but the values might be incorrect. To help tune these, can you:

1. Connect Sidecar via OBD.
2. Take a screenshot of the tire pressure parameter data redout being read by Sidecar.
3. Take note of the tire pressure being reported by your car at the moment as well.
4. Share the values here.

Thank you!

[jeff]

Some other parameters to test:

Odometer + oil level

Code: Select all

ATSH7E0
2210E0
2211BA
ATSH7E1
ATFCSH7E1
ATFCSD300000
ATFCSM1
223841
222104
2210AF

Please run the above in a terminal and then send the OBD logs to support@clutch.engineering

[b2pointoh]

@jeff thanks, i'll run these today. Where is the terminal in app? Checked docs and app, couldn't find.

[jeff]

@jeff thanks, i'll run these today. Where is the terminal in app? Checked docs and app, couldn't find.

When connected to a scanner go to settings, your scanners, tap your scanner, and you should see the terminal button there.

[b2pointoh]

@jeff TPMS isn't reporting values on the dashboard. Sensors are reading correctly from the PCM however. Sorry dont have a screenshot as need to drive car, but viewed them yesterday and know they're reporting.

As for the terminal, it requires scanpass or sub, so i can't pull values.

IMG_0790.PNG (413.53 KiB) Viewed 15368 times

IMG_0787.PNG (185.06 KiB) Viewed 15368 times

[jeff]

@jeff TPMS isn't reporting values on the dashboard. Sensors are reading correctly from the PCM however. Sorry dont have a screenshot as need to drive car, but viewed them yesterday and know they're reporting.

As for the terminal, it requires scanpass or sub, so i can't pull values.

IMG_0790.PNG
IMG_0787.PNG

@b2pointoh check your email! I sent you a subscription beta code yesterday

[jeff]

@b2pointoh and for the tire pressure, here's the full steps:

1. Connect your OBD scanner to the car.
2. Connect Sidecar to the OBD scanner by opening Settings > Your scanners and ensuring that your scanner connects.
3. Once connected, tap your connected scanner and open its Parameters page, then open the Tires page so that Sidecar starts polling the values.
4. You may need to drive the car up to a speed of 15 mph for the tire pressure values to be read.
5. Once you've done the drive, take note of the tire pressure shown on your PCM.
6. Export your OBD logs (https://sidecar.clutch.engineering/help ... -scan-logs) and email them to support@clutch.engineering, and then add a post here with the noted tire pressure values.

[jeff]

Implemented a few more of the standard parameters, including engine runtime. These will go out in the next Sidecar release (not the one I've just submitted) likely later this week.